Instruction Manual

e
f
g
b
a
i
c
h
d
5 6
Software1
When the record player is rotated, the upper part of the stabilizer is held to stop the rotation of the
stabilizer, and the stabilizer detects the rotation and shifts to the measurement mode.
When switch to the measurement mode, the display on the outer circumference of the stabilizer
starts to rotate and the [Tap to start measure] button is displayed.
Next, when you press the [Tap to start measure] button, the display changes to the [Measuring]
button and the measurement is completed in about 2 seconds.
If the end groove detection rate is low, a detection error warning mark appears.
Stop the record player when the measurement is complete.
Next, while looking at the stabilizer screen, press the record board to bring the cross mark (center of
rotation) as close as possible to the absolute center position.
The degree of eccentricity of the record is indicated by the color of the screen (outer circumference,
cross mark & display bar at the bottom).
Measuring Measurement Completed
*Please be sure to rotate the record player (33rpm or 45rpm) when measuring eccentricity.
If the record player is not rotating, the stabilizer will not enter the measurement mode.
Approx
2 sec.
Tap on the graph area
to display detailed graph data.
Measurement
Turn on the stabilizer and rotate the
record player.Measure the stabilizer
while holding it with one hand.
As the cross mark approaches the absolute center,
the color changes from red > yellow > green.
Eccentricity
Detection rate
Position A
Position B
Standby Waiting for measurement
Tap to
measure
Rotation
detected.
Stop the record player and adjust the
record disc position while watching the
cross marks on the screen
Estimated eccentricity(µ)
The percentage of correct detection is shown. The higher the detection rate, the more accurate the detection.
The distance of the end grooves from their respective sensors. (If it was at the absolute center, it would be 0.)
If the eccentricity is small, this absolute value will be small.
a
b
c
d
e
f
g
h
i
Battery level
Cross mark
Setting button
Absolute center
Before
After
Waveform graph screen
Detection error warning
Rotation display
Press the record so that the
cross mark is in the center.
300 µover 150µ under 20µ
Eccentricity and Color Indication
Adjustment
The color of the outer circumference, the cross mark, and the Before After display bar changes
variably according to the amount of eccentricity.
If the color is red, the eccentricity is more than 300µ, if yellow, it is about 150µ, and if the mark
"The center is ok" appears, the eccentricity is less than 20µ.
More detailed estimated eccentricity can be found on the graph details page.
Estimated eccentricity
Main screen