Instruction Manual

3
5
4
2
1
3
43
Names and functions
No power
Battery is dead or battery is in the
wrong direction
Replace the batteries with new ones.
Insert the batteries in the correct
orientation.
Screen is not
responding.
Please remove the batteries
and restart the system.
Trouble shooting
1. Depending on the condition of the record disc, it may not be possible to measure correctly.
(End groove position deviates significantly from the record standard, color record
Label is close to the end groove.Sound groove is close to the end groove, etc.)
2. If the warp of a record disc is too large, the stabilizer may be shaken too much and accurate
measurement may not be possible.
3. Since this product is a manual adjustment of the record position by the customer, there is a limit
to the adjustment.
Button
Used to turn on the power. Push to turn on the power.
The unit is equipped with an automatic power off function.
The power can also be turned off from the display panel. (See P8)
Display panel
Used for displaying and adjusting eccentricity status and various settings.
It is a touch panel, so please operate it with your own fingers.
Details of the software are explained in the software description page.
Rear Screw
Use the supplied wrench (Allen wrench 1.5mm) to open the main body of the stabilizer when
replacing batteries or updating software.
You can tighten the case by turning clockwise and open the case by turning counterclockwise.
Battery box
First, insert the supplied batteries to the battery box.
When the battery runs out, remove the battery from this battery box and replace the battery.
Press the metal switch
Terminal for software update
Used when software updates are required.
(We will inform you how to update the software on our website.)
Do not use this terminal except for software updates, as it may be damaged.
Detection light & light-receiving part (2 locations)
These holes are for the light emitting and receiving parts of the infrared LED for eccentricity
detection.
If these two holes are blocked, eccentricity cannot be detected.
Do not block these two holes.
Cannot be
detected
correctly
End grooves not in proper position
Low reflectivity
Record is heavily warped
Depending on the situation of the
record, detection may not be
possible.
Should any problem persist after you have checked those symptoms, please consult our
authorized dealer nearest to you.
Microcontroller error.
Symptom Cause
Corrective action
1
2
3
4
5
Battery open switch
Press to open the battery box.
6
7
7
6
Limitations of Measurement and Adjustment