SDS
Table Of Contents
- - SECTION 1: Identification
- - SECTION 2: Hazard(s) identification
- - SECTION 3: Composition/information on ingredients
- - SECTION 4: First-aid measures
- - SECTION 5: Fire-fighting measures
- - SECTION 6: Accidental release measures
- - SECTION 7: Handling and storage
- - SECTION 8: Exposure controls/personal protection
- - SECTION 9: Physical and chemical properties
- - SECTION 10: Stability and reactivity
- - SECTION 11: Toxicological information
- - SECTION 12: Ecological information
- - SECTION 13: Disposal considerations
- - SECTION 14: Transport information
- - SECTION 15: Regulatory information
- 15.1 Safety, health and environmental regulations specific for the product in question
- National regulations (United States)
- Industry or sector specific available guidance(s)
- National inventories
- 15.2 Chemical Safety Assessment
- 15.1 Safety, health and environmental regulations specific for the product in question
- - SECTION 16: Other information, including date of preparation or last revision
Notation
i inhalable fraction
lowest exposure by all routes should be carefully controlled to levels as low as possible
nano nanoparticle
noAsb_less1
Sil
contains no asbestos and less than 1% free crystalline silica
r respirable fraction
STEL short-term exposure limit: a limit value above which exposure should not occur and which is related to a 15-minute peri-
od (unless otherwise specified)
TWA time-weighted average (long-term exposure limit): measured or calculated in relation to a reference period of 8 hours
time-weighted average (unless otherwise specified
8.2 Exposure controls
Appropriate engineering controls
General ventilation.
Individual protection measures (personal protective equipment)
Eye/face protection
Wear eye/face protection.
Skin protection
- Hand protection
Wear suitable gloves. Chemical protection gloves are suitable, which are tested according to EN 374. Check leak-
tightness/impermeability prior to use. In the case of wanting to use the gloves again, clean them before taking off
and air them well. For special purposes, it is recommended to check the resistance to chemicals of the protective
gloves mentioned above together with the supplier of these gloves.
- Other protection measures
Take recovery periods for skin regeneration. Preventive skin protection (barrier creams/ointments) is recommended.
Wash hands thoroughly after handling.
Respiratory protection
In case of inadequate ventilation wear respiratory protection.
Environmental exposure controls
Use appropriate container to avoid environmental contamination. Keep away from drains, surface and ground water.
SECTION 9: Physical and chemical properties
9.1 Information on basic physical and chemical properties
Appearance
Physical state liquid
Color grey
Particle not relevant (liquid)
Odor like ammonia
Other safety parameters
Safety Data Sheet
acc. to 29 CFR 1910.1200 App D
DRYLOK® Latex Concrete Floor Paint (Dover Gray) 50g/l
Version number: REV 9.0
Replaces version of: 2023-01-11 (REV 8)
Revision: 2023-06-13
United States: en
Page: 6 / 16