SDS
Table Of Contents
- - SECTION 1: Identification
- - SECTION 2: Hazard(s) identification
- - SECTION 3: Composition/information on ingredients
- - SECTION 4: First-aid measures
- - SECTION 5: Fire-fighting measures
- - SECTION 6: Accidental release measures
- - SECTION 7: Handling and storage
- - SECTION 8: Exposure controls/personal protection
- - SECTION 9: Physical and chemical properties
- - SECTION 10: Stability and reactivity
- - SECTION 11: Toxicological information
- - SECTION 12: Ecological information
- - SECTION 13: Disposal considerations
- - SECTION 14: Transport information
- - SECTION 15: Regulatory information
- 15.1 Safety, health and environmental regulations specific for the product in question
- National regulations (United States)
- Superfund Amendment and Reauthorization Act (SARA TITLE III )
- Comprehensive Environmental Response, Compensation, and Liability Act (CERCLA)
- Right to Know Hazardous Substance List
- California Environmental Protection Agency (Cal/EPA): Proposition 65 - Safe Drinking Water and Toxic Enforcement Act of 1987
- Industry or sector specific available guidance(s)
- National inventories
- National regulations (United States)
- 15.2 Chemical Safety Assessment
- 15.1 Safety, health and environmental regulations specific for the product in question
- - SECTION 16: Other information, including date of preparation or last revision
SECTION 7: Handling and storage
7.1 Precautions for safe handling
Recommendations
- Measures to prevent fire as well as aerosol and dust generation
Use local and general ventilation. Use only in well-ventilated areas.
Advice on general occupational hygiene
Wash hands after use. Do not eat, drink and smoke in work areas. Remove contaminated clothing and protective
equipment before entering eating areas. Never keep food or drink in the vicinity of chemicals. Never place chemicals
in containers that are normally used for food or drink. Keep away from food, drink and animal feedingstuffs.
7.2 Conditions for safe storage, including any incompatibilities
Control of the effects
Protect against external exposure, such as
Frost
7.3 Specific end use(s)
See section 16 for a general overview.
SECTION 8: Exposure controls/personal protection
8.1 Control parameters
This information is not available.
8.2 Exposure controls
Appropriate engineering controls
General ventilation.
Individual protection measures (personal protective equipment)
Eye/face protection
Wear eye/face protection.
Skin protection
- Hand protection
Wear suitable gloves. Chemical protection gloves are suitable, which are tested according to EN 374. Check leak-
tightness/impermeability prior to use. In the case of wanting to use the gloves again, clean them before taking off
and air them well. For special purposes, it is recommended to check the resistance to chemicals of the protective
gloves mentioned above together with the supplier of these gloves.
- Other protection measures
Take recovery periods for skin regeneration. Preventive skin protection (barrier creams/ointments) is recommended.
Wash hands thoroughly after handling.
Respiratory protection
In case of inadequate ventilation wear respiratory protection.
Environmental exposure controls
Use appropriate container to avoid environmental contamination. Keep away from drains, surface and ground water.
Safety Data Sheet
acc. to 29 CFR 1910.1200 App D
DRYLOK® Concrete Protector
Version number: REV 2.0
Replaces version of: 2020-12-08 (REV 1)
Revision: 2021-04-09
United States: en
Page: 4 / 11