Specification

3.3 APPLICATION - GENERAL
A. Stir DRYLOK
®
WETLOOK CLEAR HIGH GLOSS PENETRATING SEALER thoroughly
before application.
B. Refer to manufacturer’s written instructions on the container or available on the manufacturer’s
website
C. Apply coating with a roller, brush, spray equipment or squeegee. Spray or back-brush first coat
to fill pores of masonry and achieve uniformity. Do not allow puddles or heavy surface film to
occur.
D. Two coats shall be applied. Allow first coat to cure 4 hours, then apply second coat by brush,
spray or roller. Apply second coat cross-directionally from first coat to achieve uniformity.
E. Additional coats can be applied on porous surfaces. Allow each coat to cure 4 hours, then apply
subsequent coats by brush, spray or roller.
F. Allow coating to cure 24 hours before subjecting to light foot traffic. Allow coating to cure 72 -
96 hours before subjecting to heavy foot traffic or vehicular traffic.
3.4 CLEANING
A. Clean material from tools and equipment as instructed in the written instructions on the
container or available on the manufacturer’s website.
3.5 PROTECTION
A. Protect work from damage of other trades during construction. Correct deficiencies or damage
by cleaning, repairing, reapplying or recoating, as approved by Architect.
END OF SECTION