User Manual

(2)
A
B
C
D
F
E
G

Figure #1
A. Paper Clamp Hand Wheel (M-S042004)
B. Back Gauge (W-O007042)
C. Paper Side Rail (W-O007028)
D. Back Gauge Lock Knob (M-S032041)
E. Blade Adjust Screw (M-S002052)
F. Blade Handle Assy. (WRA007053)
G. Safety Latch (W-O007019)

The 7000E is shipped completely assembled. Carefully remove the unit from the shipping container. Inspect for damage. If dam-
age is found, immediately notify the carrier and then call Martin Yale for instructions. Save the shipping container in case the cut-
ter requires relocation.
Place the 7000E on a flat, level work surface. To prepare the cutter for operation:
1. Make sure all four feet are in place and touching the work surface.
2. Raise the blade handle to the fullest upright position. Be sure the spring-loaded safety arm is engaged.
3. Note the back gauge is secured in position on the side rail with the locking knob.
4. Note the measuring scale on top of the side rail. The scale is calibrated in both inch and metric readings that provide accurate
back gauge settings.

Do not attempt to operate the 7000E until you have read and thoroughly understand this manual. The following procedure
should be followed when loading, cutting, and unloading paper from the 7000E.
1. Lift the blade handle to the fullest upward position. Make sure the blade handle is locked in place by the safety latch.
2. Raise the paper clamp to the required height by rotating the clamp wheel counter-clockwise.
3. Loosen the locking knob on the back gauge. Align the back gauge to the point on the measuring scale that corresponds to the
required cut. Retighten the locking knob while pressing the back gauge firmly down on the wood top.
4. Place the paper stack through the cut opening and align the stack of material flush with the side rail and back gauge.
(7)
6.0 7000E Parts Diagram