Assembly instructions
Table Of Contents
- Table of contents
- 1 Safety instructions
- 2 Note
- 3 Unpacking
- 4 Setting up the bass drum
- 5 Assembling the floor tom
- 6 Assembling the bass drum pedal
- 7 Assembling the hi-hat
- 8 Assembling the cymbal stands
- 9 Assembling the snare drum stand
- 10 Tuning the shells
- 11 Setting up the drum set
- 12 Attaching the cymbals
- 13 Protecting the environment
The batter head without logo print is used on the beater side. When mounting it, we
proceed in just the same way as with the resonator head. Put the head on rst and
lay the hoop on it, put the washers and claw hooks on the tension rods and screw
them on. Do not tighten them too much; only enough for the hoops not to be
shifted. We'll do everything else when we tune the drums. So that's the bass drum
nished; now we'll do the toms.
Mounting the beater head
Setting up the bass drum
10
DrumCraft Series
drum set