Instructions
25
27. FCC Note
Caution:
This device complies with Part 15 of the FCC rules and Industry Canada license-exempt
RSS standard(s). Operation is subject to the following two conditions: (1) this device may
not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modications or change to this equipment. Such modications or change
could void the user’s authority to operate the equipment.
This radio transmitter (identify the device by certication number or model number if
Category II) has been approved by Industry Canada to operate with the antenna types
listed below with the maximum permissible gain indicated. Antenna types not included in
this list, having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following measures:
■
Reorient or relocate the receiving antenna.
■
Increase the separation between the equipment and receiver.
■
Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
■
Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement.
To maintain compliance with FCC’s RF exposure guidelines, this equipment should be
installed and operated with a minimum distance of 20 cm between the radiator and your
body.
28. Produkt-Support
Wenn Sie technische Hilfe benötigen, besuchen Sie bitte http://droneart.com/help-and-
support/ oder rufen Sie uns an unter +852 2559 2662. Zusätzlich steht Ihnen für jegliche
Anfragen unser Online-Ticket-System unter http://support.droneart.com/ zur Verfügung.
29. Rechtliche Hinweise
Diese Bedienungsanleitung wurde von CEI Conrad Electronic International (HK) Limited,
18th Floor, Tower 2, Nina Tower, No. 8 Yeung Uk Road, Tsuen Wan, New Territories, Hong
Kong veröffentlicht. Alle Rechte vorbehalten, einschl. Übersetzung. Die Vervielfältigung
durch irgendeine Methode, d.h. Fotokopie, Mikrolm oder in einer digitalen, elektronischen,
optischen oder in anderer Form erfordert die vorherige schriftliche Genehmigung
vonseiten des Herausgebers. Die Vervielfältigung durch Drucken, auch teilweise, ist
ebenso untersagt. Diese Bedienungsanleitung entspricht dem technischen Stand bei
Drucklegung.
© 2017 by CEI Conrad Electronic International (HK) Limited
88025RC_v2_1217_02_m_jh_de_(1)