User Manual

4
FLYING BASICS
If this is your  rst time piloting a multi-rotor craft, you will
 nd that the controls are intuitive and you will have a feel for
basic  ight by the end of your  rst battery. Mastering  ying,
however, takes some practice and patience. We recommend
that you always  y in control and within your piloting ability.
1. Place the quad on the ground at least 6 feet away with the
tail facing you. Make sure the control rate is set to 20%.
2. Take off by “slowly” advancing the left stick until the quad
takes off. Change the altitude using small movements.
3. Use the right stick to make the quad move left, right,
forward or backward. Keep in mind that when the nose
is facing you, the right stick controls will appear to be
operating in opposite directions, i.e., moving the right
stick to the right will now move the quad left from the
pilot’s perspective.
4. Moving the left stick to the left or right will rotate the nose
of the quad left or right.
5. Always use small stick movements to control the quad
until you are familiar with the how the model responds
to the controls.
6. Always unplug the battery and turn off the controller when
you’re done  ying.
INVERTED FLIGHT
Unlike your typical multi-rotor craft, the Verso quad is capable
of taking off upside-down or  ipping itself inverted during
 ight with the press of a button and then continuing to  y
normally. Sensors on the quad automatically detect which
side of the quad is facing up and will adjust the rotation of
the motors accordingly. Because of this feature, there is some
functionality that is unique to the Verso quad:
● When the Verso quad is  ipped 180º using the  ip button
in the direction of front-to-back, the forward and reverse
controls are automatically swapped so your perception
of what is forward has not changed. This means that
if the colored props were considered the front of the
quad before you  ipped front-to-back, they will now be
the rear of the quad.
● When the quad is  ipped 180º left-to-right, the controls
do not change.
● Whenever the throttle is moved to the lowest position,
the direction control always defaults to the colored props
being the front of the quad. It does not matter which
side of the quad is facing up.
The default setting for the  ip
function is 180º. To change
the  ip function to 360º, press
and hold the  ip button for
at least two seconds. The
transmitter beeps once for
180º mode and beeps twice
for 360º mode.
LOW BATTERY INDICATORS
Total  ight time with a fully charged battery will be approximately
7 minutes if the Verso quad is  own until the automatic cutoff
shuts down the motors. When the battery voltage approaches
the cutoff voltage, the LEDs on the quad will  ash. At this
point the  ip function will be disabled. We recommend you
land the quad and charge the  ight battery.
When the controller batteries become depleted, the battery
symbol on the controller LCD screen will  ash and you will
hear an audible warning.
To prevent motor damage always be sure
the throttle is off when the blades are
obstructed or control is lost.