Technical data

Page 3 of 15
INSTALLATION INSTRUCTIONS
LOCATING THE APPLIANCE
• Position the appliance as close as possible to the chimney.
• Many configuration are possible, the most frequent are illustrated in figures 1,2 and 3.
• Respect clearances indicated on page 1. They have been tested according to approvals.
• Always respect clearances of appliance pipe manufacturers. Larger clearances always prevail.
Figure 1 : CORNER INSTALLATION
Figure 2 : PARALLEL INSTALLATION
Figure 3 : WALL INSTALLATION
Table 1 : CLEARANCES TO COMBUSTIBLES
mm in
Back 180 7
Side 150 6
Corners 150 6
Top 915 36
Flue Pipe 230 9
• IMPORTANT: It is essential to ensure that the room in which the appliance is installed is sufficiently
ventilated to provide an adequate air supply.
• It is possible that if your home is well insulated, that you will have to install an outside fresh air intake.
THE BURNING OF ONE LITRE OF FUEL (OIL) REQUIRES APPROXIMATELY 30 M
3
OF AIR AND WILL
PRODUCE ABOUT 0.8 KG OF WATER OF WATER VAPOR AND 9 M
3
OF CARBONE DIOXIDE AND
ATMOSPHERIC NITROGEN. A SOURCE OF AIR FROM THE OUTSIDE IS NEEDED TO REPLACE
COMBUSTION AIR.