Installation manual

AIR CIRCULATION SYSTEM
________________________________________________
• Optional accessories for air circulating system.
• Blower (100 CFM) c/w speed control.
• This blower attach to the second wall which covers the back of your stove. This second wall
acts as a heat exchanger. Air enters at the back, circulates between heat shield and the stove
and is projected toward front when heated.
______________________________________________________
OPERATING INSTRUCTIONS
______________________________________________________
a) Only wood should be used as fuel.
b) Drolet stoves are not designed for a wood cradle, nor do they provide support facilities for
the wood. Therefore, never use grate or elevated fire. They would generate excessive
temperature.
c) When using your unit for the first time, to avoid thermic shocks do not heat your stove to the
maximum. This causes the painted surface to deteriorate. Be sure that ventilation in the
room is adequate. This will prevent any inconvenience arising from smoke and disagreeable
odor given off by heated paint.
d) Before lighting your stove, be sure that the air control is wide open. If you feel air currents
coming from the chimney, slightly open a window close by and hold a lighted paper in the
opening as close as possible to the flue outlet. This will heat air in the chimney.
e) When the paper and dry wood have been lighted, keep the air control in position "Open" until
you have obtained a good fire. From then on, you may add larger logs of wood until a bed of
embers has built. It is recommend during pre-heat period to leave the door slightly open to
ease combustion.
f) We recommend the use of a magnetic thermometer on your stove pipe. It should be installed
18 inches above the stove top, to indicate the gas temperature. We also recommend to adjust
the air intake to maintain the gas temperature always above 300
o
F.
g) Before you open doors to reload or check level of combustion, open the air control to permit
gases and smoke to leave.
5