Product Manual

Eco-65 Installation and Operation Manual

8.3.6 N Code

THE STOVE FUNCTIONS BUT DISPLAYS WARNING CODE

Possible Cause:

Possible Remedy:

A reversed polarity is detected on the

electrical outlet or on the same electrical

circuit.

Test and ensure the proper connections.

No ground is detected or connected in the

wall outlet.

Test and ensure the proper connections of

the electrical wires and/or correct the grounds

of the unit.

8.3.7 C Code

THE STOVE FUNCTIONS BUT DISPLAYS WARNING CODE

Possibles Cause: Possible Remedy :

Warning generated by a power failure

while the stove was running.

The stove will restart on the initial setting once it

cools off.

Note: For a short power failure (less than 5

seconds), the stove will continue to function at the

selected speed.

8.3.8 I Code

STOVE FEEDS PELLETS, BUT WILL NOT IGNITE AND APPEARS ON THE

CONTROL BOARD

Possible Cause: Possible Remedy:

1. The igniter fuse on the control board

has blown.

Test the resistance (ohms, Ω) with a

multimeter. If the value is near zero, replace

the igniter and the F3 fuse.

2. The wiring harness shorted. Inspect the wiring and replace any defective

wire and or connector. Make sure the wires

are not shorted to the stove frame. Locate the

fuse F3 on the control board and replace it.

See Section 9.2: Testing a Component)

and follow instructions for component check.

Test the igniter to see if it glows. It should

take no longer than two minutes.