Product Manual

Eco-65 Installation and Operation Manual

8.3.2 H Code

STOVE STOPS FEEDING PELLETS AND APPEARS ON THE CONTROL BOARD.

BEFORE RESETTING TAKE CARE IN READING THE POSSIBLE CAUSES AND THEN

PRESS ON AND AT THE SAME TIME FOR 2 SECONDS.

Possible Cause: Possible Remedy:

1. Inadequate fuel is used.

Remove the burn pot, make sure that all

openings are clear and check that no ash has

filled the tube around the igniter. Refer to the

maintenance section. Also, make sure that

the recommended fuel is used (see Section

4.8.1: Proper Fuel).

2. The flue is not properly installed. Make sure the venting system meets the

criteria in the Section 4: Venting System as

well as the venting system manufacturer’s

instructions.

3. The flue is blocked or needs cleaning. One of the following components is

obstructed or blocked; air intake shutter,

combustion blower, burn pot, heat

exchangers and channels, exhaust blower

and or venting system. Refer to Section 7:

Maintenance.

4. The stove needs maintenance. Refer to Section 7: Maintenance.

5. The burn pot is not installed properly. Make sure the burn pot is installed correctly

(see Section 7.1.4: Cleaning the Burn Pot).

6. The baffle is not installed properly or holes

may be blocked.

Make sure the baffle is well installed and the

lock is in place. Make sure the holes are clear

(see Section 7.1.2: Cleaning the Baffle, the

Heat Exchanger and the Combustion

Chamber).

7. The convection blower is defective. See Section 8.2: Testing a Component and

test the convection blower.

8. he combustion blower needs cleaning. Carefully clean blower housing and make

sure blower louvers are not blocked.

9. The exhaust blower is defective. See Section 8.2: Testing a Component and

test the exhaust blower.