Product Manual

Eco-65 Installation and Operation Manual

6.2 Everyday Startup

Before starting the stove, make sure there is enough pellets in the hopper and that the

recommended maintenance schedule has been followed (see Section 7.1.1:

Recommended maintenance schedule). Press the icon for either MANUEL or

THERMOSTAT.

6.3 Running Out of Pellets

If your stove runs out of pellets, the fire will slowly go out; the convection fan will run until the

heat sensor on the exhaust fan reads 115°F. The cooling cycle will take a few minutes before

all other motors stops. When this temperature is reached, a warning message will appear

on the screen.

To restart the stove, wait until all components stop running (usually 10 minutes after the

warning message has been displayed). Press the button, refill the hopper, and press

the auger icon .

6.4 Refueling

While the stove is running, you have up to 3 minutes to refill the hopper with pellets. Note that

opening the hopper lid will stop the auger from feeding pellets to the stove. If the hopper lid is

left open more than 3 minutes, the stove will stop and a warning code will appear on the

control panel. To restart the stove, close the lid, press the button, and then press the

to select either MANUAL or THERMOSTAT.

NOTE: Keep hopper lid closed at all times except when refueling. Do not overfill the

hopper.

6.5 Shutting Down Procedure

To turn your stove off, press the button on the control panel until the LED light is in the

OFF position. The cooling cycle will take a few minutes and the blowers will continue to

function while the stove is cooling down.

IMPORTANT: DO NOT DISCONNECT THE POWER CORD TO TURN OFF THE STOVE.