Product Manual

HeatPack Furnace Installation and Operation Manual

PART 1 – INSTALLATION

Refer to Part 2 of this manual for operation, maintenance and troubleshooting instructions.

Refer to Part 3 of this manual for the furnace features and safety instructions.

1 Introduction

This furnace uses the same wood burning technology as a high efficiency certified CSA

B415.1-10. This model meets the emissions limits of CSA B415.1-10 Standard.

We recommend that our woodburning hearth products be installed and serviced by

professionals who are certified in the United States by NFI (National Fireplace Institute

) or

in Canada by WETT (Wood Energy Technical Training) or in Quebec by APC (Association

des Professionnels du Chauffage).

ATTENTION

FOR INSTALLATION OF A CENTRAL HEATING VENTILATION SYSTEM, IT IS HIGHLY

RECOMMENDED TO CONSULT A HEATING SYSTEM VENTILATION SPECIALIST.

WARNING

STOVE BUILDER INTERNATIONAL INC. IS NOT RESPONSIBLE FOR POOR

APPLIANCE PERFORMANCES, DUE TO IMPROPER INSTALLATION OF EXHAUST

SYSTEM OR DUCTING.

BEFORE STARTING THE INSTALLATION

 READ THE ENTIRE MANUAL AND MAKE SURE YOU UNDERSTAND IT. (IF IN

DOUBT, CONTACT OUR CUSTOMER SERVICE). FAILURE TO COMPLY WITH

THIS MANUAL MAY RESULT IN HAZARD TO YOUR SAFETY AND WILL VOID

YOUR WARRANTY.

 INSPECT THE FURNACE TO MAKE SURE THAT NOTHING HAS BEEN DAMAGED

IN THE SHIPPING. PULL OUT THE TOOLS FROM THE FLUE PIPE AND/OR

EXCHANGERS AND FIREBOX OF THE FURNACE.