Product Manual

HeatPack Furnace Installation and Operation Manual

Appendix 1: Optional thermostat installation

Using a thermostat will help you maintain a constant temperature throughout the house. A

fixed wall mounted 24v thermostat is required.

NOTE

THERMOSTAT MANUFACTURER’S INSTRUCTION ALWAYS OVERRIDES THE

INFORMATION PUBLISHED IN THE FOLLOWING SECTION.

Thermostat location

- Must be installed on an inside wall of the

house;

- Where it will be the least affected by

affected by air currents from a hot air outlet

or cold outside walls;

- Must be installed at a minimum of 55" (140

cm) above the floor.

- Must be installed at a minimum of 15’ (4.57

m) from the furnace and must not receive

radiation from the glass door.

Thermostat wiring – Stand Alone Installation

 Before installing the thermostat,

disconnect the furnace from the outlet.

 Use an 18 AWG 2 strand wire.

 The terminal is located at the back on

the rear right side of the furnace when

facing it. It is marked with the letter “T”.

 Loosen the two screws in the middle of

the terminal bloc and insert the wires

in the terminals. Tighten the two

screws.

 Open the thermostat housing and

connect the wires following the

manufacturer's instructions.