Product Manual

HeatPack Furnace Installation and Operation Manual

o Mechanical ventilation system: if the house is equipped with a ventilation system (air

exchanger or heat recovery), the ventilation system may provide sufficient auxiliary air

to the solid fuel unit. Otherwise, the owner should be informed that the ventilation

system may have to be rebalanced by a ventilation technician after the installation of

the solid fuel unit.

9 Electrical connection, adjustment of components and

calibration of the draw

The furnace is fully assembled at the factory and no electrical connection is required other

than plugging the power cord into an outlet.

9.1 Raccordement électrique

WARNING

 THE FOLLOWING INSTRUCTIONS DO NOT REPLACE THOSE OF THE LOCAL

CODE.

 INSTALLATION AND VERIFICATION OF THIS APPLIANCE MUST BE DONE BY

A QUALIFIED PERSON.

 ONLY USE WIRES SUITABLE FOR 167 °F (75 °C) OR MORE

All wiring from the service panel to the heating unit must comply with the electrical code in

force and all local regulations. It is recommended to feed the furnace with its own electrical

circuit of 15 amps at 120 volts with a breaker (see wiring diagram).