User`s manual

Operation of DR3
- 14 -
3.5 LANC Remote Control
The DR3 support multi-version LANC Remote Control, please power off DR3 &
unplug AC Power adapter, then plug LANC remote control into LANC jack with
logo.
NOTE : SkyTools CamEYE SPORT LANC Remote Control V1.4 & V1.6 are supported by the
DR3 .
Power on the DR3 , after booting is finished, you can control the DR3 start/stop
recording using LANC remote control. And you can power off DR3 & power on it
again.
After the DR3 starts successfully, the status LED on LANC remote control will display
green. Press the button on the center of LANC to start recording, and the status LED on
LANC will flash red & the unit beeps 3 times once started successfully.
Press button again, the DR3 will stop recording; the status LED on LANC turns to
green.
Holding the button on LANC for approx 3 seconds until the status LED on LANC
flashes red. This will power down the DR3 , when the DR3 powers down, the status
LED on LANC turns to yellow.
In power off status, press button on LANC to power up the DR3 again.
NOTE : DO NOT PLUG OR UNPLUG LANC REMOTE CONTROL WHEN
DR3 POWER ON & AC POWER ADAPTER IS CONNECTED !! YOU MUST
POWER DOWN THE DR3 , UNPLUG AC POWER ADAPTER, THEN
PLUG/UNPLUG LANC REMOTE CONTROL.
3.6 Power Off/On TFT LCD on DR3-X1 & 2/3/4CH DR3
To save the battery power, you can enable the DR3-X1 & 2/3/4CH DR3 TFT LCD off
automatically depend on the timer that you set.
The default status of LCD OFF is disabling.
You can enable LCD OFF function & set feat timer under LCD configuration menu.
When you enable LCD OFF function & set timer, the TFT LCD on DR3-X1 will
power off automatically at once special timer that you set finish.