User`s manual

DR3 User’s Manual
- 179 -
14. Firmware Upgrade
NOTE: Please don’t connect camera & other external device to DR3 when you
upgrade DR3!
The firmware of the DR3 can be upgraded if necessary. The DR3 will check the core
image file on CF card while power up. If image & OSD file is found then the firmware
of the DR3 will be upgraded automatically. Please follow below instructions to
upgrade.
1) Format CF card in FAT32 file system.
2) Copy imge.2510.img and osd.img to the root of CF card.
3) Use DR3 Desktop to generate DEVICE.INI depended on your needs.
DEVICE.INI must be under the root of CF card while upgrading.
4) Power off and then insert CF card into DR3 .
5) Turn on the power of DR3 .
6) The firmware will be upgraded after power on. The LED turns to red, then yellow
and alternately flashes red and yellow several times. It takes about two minutes to
upgrade.
At the same time, LCD will display schedule of upgrade process if you upgrade
from Firmware V1.0.4 or newer.
When the DR3 upgrades successfully, it will reboot automatically.
Update DR3-S1
Update DR3-X1
* DON’T TURN OFF POWER DURING THIS PERIOD!!
7) The DR3 will be rebooted automatically after upgrade. The LED will change to red,
yellow and then green. It takes about 12 seconds to reboot.
8) Over if the LED is green. A Beep will sound one time once the DR3 upgrades
successfully.