User`s manual

Operation of DR3
- 12 -
3.2 Push Button
3.2.1 RECORD
Press the (REC) button on top of DR3 for at least one second to start recording.
The LED will flash red and you will hear three beeps.
The flash frequency is about 3 times per second. Slower flash frequency means no
video signal is connected.
3.2.2 STOP
Press the (STOP) 3-Position button for at least three seconds to stop recording. The
LED turns to green & you will hear 2 beeps.
It will take a short while to save buffered data after stopped. The power can not be turn
off until the LED changes to green. Early eject the CF card will cause destroy of video
file integrity. Disconnect AC power adapter and switch off battery before eject CF card.
3.3 Infrared Remote Control
Infrared remote control is optional for DR3 .
Three buttons are defined currently:
Start recording
Stop recording
Keep pressing to make DR3-S1n Standby/Wakeup mode
3.4 Infrared Remote Control for 2/3/4 Channels DR3
The numeric key on the IR remote controller controls 9 positions of Picture-In-Picture,
you can configure it & select any one array method as your default array using the DR3
Desktop.
You can switch the array method using numeric key on the IR remote controller directly
when you record the video using 2/3/4 Channels DR3 . The numeric key 1~9 is opposite
with 9 items in Position pull down menu.