User`s manual

Configuration DR3 using LCD Menu
- 126 -
13. Configure DR3 by LCD Menu
13.1 Configure DR3-S1 using LCD Menu
13.1.1 Enter/Quit LCD Configuration Menu
Hold push the 3-Position button at least 3 seconds to enter LCD configuration menu,
once you enter LCD configuration menu successfully, the LCD will display valid
menu/menu item & parameter of these menu item depend on your DR3-S1 version.
After you finish configuration, press button or Key on IR remote control to
quit to upper menu.
You may need press button or Key on IR remote control one or two times
once depend on your position in menu.
Once you enter the LCD configuration menu, the system will wait for you to select &
configure, if you don’t press any buttons, the system will quit the LCD configuration
menu after 10 sec automatically.
13.1.2 Configure DR3-S1
You can configure DR3-S1 in LCD menu via push switch/button or IR remote control.
13.1.2.1 Configure DR3-S1 using switch/button
Once you enter LCD configuration menu, you can switch menu using LEFT &
RIGHT position of 3-Position switch, then press button to select the menu/menu
item which you want to configure, using LEFT & RIGHT position of 3-Position
switch to select the parameter value & parameter area that you want to configure, and
then press button to save the configuration.