User`s manual

DR3 User’s Manual
- 5 -
2.2.3 Startup
1) Connect AC power adapter
2) DR3 will start self-diagnostics when power on
3) The LED is red in self-diagnostics and will turn yellow on start-up. The LED turns
to green once start-up successful.
It takes about 12 seconds to startup
4) The LCD displays Init… during startup, after startup successful, the LCD will
display DR3
5) You will hear a beep one time once DR3 start-up
6) The battery will be charged automatically when power on and LED turns on red
The battery should be fully charged before first use. The charging LED goes out once
charge finished.
Please charge the internal Li-Ion Polymer battery over night & until the charging LED
goes out. Li-ion Polymer rechargeable battery is expendable.
The battery should be replaced after 500 charge cycles. The used battery should be
disposed properly.
2.2.4 Safety and Warning
* Never connect Multi-Connect Cable Power output to any power adapter. It may be damage the interface and
board.
* There are no user serviceable parts, please do not open the unit. Doing so can damage the unit and will void
your warranty.
* Restrict input voltage to range from 9V to 15DC, 12V DC is recommended. Never apply DC voltage beyond this
range or AC voltage to the DR3 .
* Only use AC power adapter supplied with the unit. Do not use third party AC power adapter, it may cuase
unexpected problems or damage.
* Restrict powering devices drawing more than 200mA current for 1CH DR3 .
* Restrict powering devices drawing more than 700mA current for 4CH DR3 .
* When DR3 powered by internal battery, don’t connect camera more than 1pcs for 1CH DR3. And don’t connect
cameras more than 2pcs for 2CH/3CH/4CH DR3 .
* Never insert and remove CF card while power is on.