User manual

DR2 User Manual
- 5 -
Startup
1) Connect AC power adapter
2) DVR will start self-diagnostics when power on
3) The LED is red in self-diagnostics and will turn yellow on start-up. The LED turns
to green once start-up successful.
It takes about 12 seconds to startup
4) The LCD displays Init… during startup, after startup successful, the LCD will
display DVR
5) You will hear a beep one time once DVR start-up
The Vibration Motor will vibrate one time once when DVR start-up successfully *
6) The battery will be charged automatically when power on and LED turns on red
The battery should be fully charged before first use. The charging LED goes out once
charge finished.
Please charge the internal Li-Ion battery over night & until the charging LED goes out.
Li-ion rechargeable battery is expendable.
The battery should be replaced after 500 charge cycles. The used battery should be
disposed properly.
* The Beep & Vibration Motor is only one in DVR, The Beep is standard part, Vibration Motor is optional only
for special model.
Safety and Warning
* Never connect IRIS-Power output to any power adapter. It may be damage the interface and board.
* There are no user serviceable parts, please do not open the unit. Doing so can damage the unit and will void
your warranty.
* Restrict input voltage to range from 9V to 15DC, 12V DC is recommended. Never apply DC voltage beyond this
range or AC voltage to the DVR.
* Only use AC power adapter supplied with the unit. Do not use third party AC power adapter, it may cuase
unexpected problems or damage.
* Restrict powering devices drawing more than 200mA current for 1CH DVR.
* Restrict powering devices drawing more than 700mA current for 4CH DVR.
* When DVR powered by internal battery, don’t connect camera more than 1pcs.
* Never insert and remove CF card while power is on.