Specifications

How to use Digital Operation
12.2.4
Checking the software version
12
-22
12.2.4 Checking the software version
This mode is used for maintenance of the motor.
When Fn012 is set, this mode becomes the software version checking mode.
To check the software version, use the following procedure.
1. On the axis selection mode, select the axis you want to operate.
2. Set Fn012.
3. Press the [DATA/ENTER] key to view the SERVOPACK software version.
4. Press the [DSPL/SET] key to view the software version of encoder which is mounted on
the motor.
5. Press the [DATA/ENTER] key to return to the user constant number display.
This completes checking the software version.
Display of software version
Software
version
Display of software version
Software version