Specifications

12.1
Basic operation
12
-5
12.1.5 Axis selection mode
On the axis selection mode, select an axis you want to operate.
 How to use the axis selection mode
Here is the procedure to select the second axis.
1. Turn on the power supply, the axis selection mode displays.
2. Select the axis number you want to operate.
Press the [UP] or [DOWN] key, and the axis number is changed.
(In this case you select "dr2".)
3. Press the [DATA/ENTER] key. The status display mode for the axis you selected on
Step 2 is displayed.
Now the second axis has selected.
To return to the axis selection mode, press the [DATA/ENTER] key on the status display
mode.
The first axis of the 1-axis drive and 2-axis drive is the rotary switch number of each drive plus one.
The second axis number of the 2-axis drive is the rotary switch number plus two.
On the mode other than the axis selection mode, the LED of the drive which is selected flashes.
12.1.6 Status display mode
In the status display mode, bit data and codes are used to indicate the status of the SERVO-
PACK.
 Indication on the status display mode
The indication of status display mode is different between the speed control mode and the
position control mode.
INFO