Specifications

12.1
Basic operation
12
-3
12.1.2 Function of digital operator
The digital operator allows you to set each user constant, to execute the operational com-
mand, and to view the state indication.
The following table describes the names and functions of the keys of digital operator which
displays the initial screen.
12.1.3 Reset of servo alarm
You can reset the servo drive alarm via the digital operator; press the [RESET] key on the
status display mode.
When there occurs an alarm, first eliminate the cause of alarm and then reset the alarm.
digital operator Key Name Function
RESET key To reset the servo drive alarm, press this key.
DSPL/SET key • To switch over the status display mode, the
auxiliary function execute mode, the con-
stant setting mode, and the monitor mode,
press this key.
• This key can function as the data selection
key on the constant setting mode.
DATA/ENTER key • To display the setting and setting value of
each user constant, press this key.
• To switch over the axis selection mode and
the status display mode, press this key.
Va l u e mo di-
fication/JOG
key
UP key • To increase the setting value, press this key.
This key can be used as the reverse start key
on the JOG operation.
• On the axis selection mode, press this key in
order to increase the axis number.
DOWN key • To decrease the setting value, press this key.
This key can be used as the reverse start key
on the JOG operation.
• On the axis selection mode, press this key in
order to decrease the axis number.
Digit
selection key
RIGHT key • To select the setting digit you want to mod-
ify, press this key. The flashing digit means
to be available.
• By pressing the RIGHT key, the digit
decreases by one (shifts toward right).
• By pressing the LEFT key, the digit
increases by one (shifts toward left).
LEFT key
SVON key To enable the JOG operation with digital oper-
ator, press this key.
SERVOPACK
ALARM
DIGITAL
OPERATOR
JUSP-OP02A
RESET
DSPL
SET
DATA
ENTER
JOG
SVON
YASKAWA
ALARM
RESET
DSPL
SET
DATA
ENTER
JOG
SVON
IMPORTANT