Specifications

11.1
Drive Parameter Screen Operation
11
-5
On the drive parameter screen, press the [INPUT] key after having input the data in order to write the
data into the drive.
Take notice that the method of data input on the drive parameter screen is different from that on the
other machine data setting screens.
 Switching over the target axes
The axis-specific drive parameter can be displayed by switching over the target axes.
Use the following procedure;
• Press the [Drive + (F9)] key to display the drive parameter of the axis number that is the
current axis number plus one. If you click the "final page", there displays the axis num-
ber on the top page.
• Press the [Drive − (F10)] key to display the drive parameter with the axis number that is
the current axis number minus one. If you click the "top page", there displays the axis
number on the final page.
• Press the [Direct selection (F11)] key to display the dialog box for direct switching (see
the figure below). Press the [INSERT] key to display the list of drives you can switch
over. When selecting one from the list, there displays the screen of the selected drive
number.
 Searching
There are two types of searching methods; the parameter number method and the parameter
name method.
The searching procedure is as followings.
1. Press [Search . . . (F14)] key.
2. There displays the search dialog box .(See the figure below)
3. Input the parameter number or the parameter name. Alternatively, by pressing the
[INSERT] key a list of the latest key input history (up to eight) is displayed. You can
select the search key from the list.
4. Press the [INPUT] key or [OK (F16)] key to execute the search. To cancel the search,
press the [Abort (F15)] key.
5. When the search key is sought out, the screen jumps to display the result. When the
search key is not found, the cursor remains standstill and the error message "7. Search
term not found." is output.
IMPORTANT