Specifications

Drive Parameter Screen
11.1.3
Operation method
11
-4
11.1.3 Operation method
On the drive parameter screen, the following operations are available.
 Basic operation
The basic operations are listed below;
• Use the upward/downward arrow key for one-line scroll.
• Use the right/left arrow key to transit the selected row by one.
• Use the PAGE UP/PAGE DOWN key for one-page scroll.
• Use [Drive + (F9)] key or [Drive - (F10)] key for switching the displayed target axes.
• Use [Direct selection (F11)] key for the direct switching for the target axis displayed.
• Use [Search . . . (F14)] key for searching.
• Use [Continue search (F15)] key for continuing the search.
• Use [Refresh (F16)] key to update the displayed data.
• Use [Back (F1)] key to goes back to the last page.
• Without connection to the drive, [Drive +] key, [Drive − ] key, [Direct selection] key,
[Search . . . ]key, and [Continuous search] key are not available.
 Input of setting value
The input method of setting values are categorized into 3 types; decimal number, hexadeci-
mal number and binary number.
Decimal number
Decimal number data can be input using only the numeric keys. However, if the parameter
can accept minus data, [-] key input is permitted.
Hexadecimal number
Hexadecimal number data is displayed with "H" at the end of the value. The numeric keys
from 0 to 9 and alphabetical letter keys from A to F input is available.
Binary number
Binary number data is displayed with "B" at the end of the value. Only [0] and [1] key input
is accepted. Press the [INSERT] key to switch over to the inset mode. On this mode, you can
goes to the bit position you want to modify by using [->] and [<-] keys. The input is limited
to up to 16 digits. If there are already input up to 16 digits on the insert mode, you must
delete any number using the [DEL] key.