Specifications

10.2
MD components
10
-5
10.2 MD components
The following diagram shows the drive-related MD and the screen display types.
Schema of 840DI system
YS(840DI)
PLC (MCI board) ･PLC application NCK (PCU) ･
NCK application
･
CNC program analysis
･Interpolation,
Acceleration/Deceleration
･
Position control
(CNC-side processing) ･Backlash, Pitch errors ･
Tool replacement,
Data management Machine data
PROFIBUS
I/F
(MCI board)
HMI (PCU) ･
ShopMill screen
･Standard HMI (Maintenance screen) ･
HMI application
Customer HMI (Exclusive customer screen
)
･HMI application
Converter(MRXN)
Data bus Data bus Data bus Data bus LatchSinal L atch signal Latch signal Battery supply Battery supply Battery supply Battery supply
Soft ware (0 0) No parameter
Main soft ware (F0**)
Main soft ware (F***)
Main soft ware (F***)
Main soft ware (F***)
Main soft ware (F0**)
Main soft ware (F0**)
Parameter Cn000 1**,2**,4**,5**
Parameter Pn000 1**,2**,3** ,4**,5**
Parameter Pn000 1**,2**,3**, 4**,5**
Parameter Pn000 1**,2**, 3**,4**,5**
The same as
the left
column
The same as
the left
column
General Channel
Axis
Drive parameter
DISPLAY
-MD
Digital
operator
General
Channel
MD 10000
19***
(Display screen is single) MD 20000
29***
(Display screen is single)
Axis MD 30000 38000 (The display screen has a page(s) per *axis.)
SP
□
X axis
□
Y axis
□
Z axis
□
B axis
□
Spindle inverter
(MXN)
Feed X axis(SGDK) Feed Y axis Feed Z/B axis
<1-axis drive><1-axis drive><2-axis drive><1-axis drive>
Drive parameter (Spindle) MD 6000 to 8999 (Servo drive) MD 3000 to 5999
SP
□
X axis
□
Y axis
□
Z axis
□
B axis
□
･
PRM number
→
MD
numbers are changed in alignment ･
The content of setting is
also changed from decimal number (drive side) to hexadecimal number (NC side).
W axis
□
W axis
□
Standard setting, Function Enabled/Disabled Mode setting, Compensation Value, Max/Min. Value
setting, and Setting of Gain or Integral Time Constant for the specific function
Content of parameter ・
Mode/Function setting
・
Gain
・
Integral time constant
・
Adjustment of the axis
behavior ・
Toque level
Feed W axis
Type:JUSP-JOP02A
Monitor PRM -> (Un0**) Function PRM -> (Fn0**)
Monitor PRM -> (Un0**) Function PRM -> (Fn0**)
Monitor PRM -> (Un0**)
Function PRM -> (Fn0**)
The same as
the left
column
The same as
the left
column
Monitor PRM -> (Un0**)
Function PRM -> (Fn0**)
Automatically set to the first address number + 1
Specified with even numbers
Indication/Axis-specific setting/ Content forwarding
Local bus setting number
↓
↓ ↓ ↓
"dr-#" indication
NC-side screen
configuration
NC-side screen
configuration
"X axis" indication is defined with MD1000. The number in the " " is defined with MD20050.
Local bus setting RSW Local bus setting RSW Local bus setting RSW
Profibus setting is defined through the hard ware configuration.