Specifications

9.3
Uploading hardware configuration
9
-23
9.3.3 List of addresses
You can display a list of addresses that are used in hardware configuration.
To bring up this screen, click on the address list icon of the hardware configuration screen.
The content of the address list screen is as follows:
Address from Select a module whose address list you want to display. Normally the names of avail-
able CPUs are shown. The name of CP is also shown if the CP is configured as a DP
master.
Filter Input Input addresses are to be listed.
Output Output addresses are to be listed.
Address gap Address gaps are to be listed
* (address gaps are the addresses currently not used).
Type I: Input address
I*: Input address of diagnosis byte
Q: Output address
Addr: From Module’s start byte address
Addr: To Module’s end byte address
Module Module type
DP For DP slaves, a DP address is shown in the parentheses ( ).
R Number of a rack in which the module is contained
S Number of a slot in which the module is inserted
IF Interface port number