Product Manual

INSTRUCTIONS FOR USE
The REMOTE control has an LCD display, Intensity Up(+) and Down(–) and C button for choosing which
RECEIVER you plan to adjust. Channel 1 controls RECEIVER 1, while Channel 2 controls RECEIVER 2.
The M button is to control the MODE functions of the 2 RECEIVERS.
REMOTE CONTROL
The slide SWITCH(1) on the bottom of the REMOTE is to turn the unit “ON” and “OFF”. Its LCD display
lights up when the REMOTE is “ON”. If the LCD display is blank or the REMOTE does not turn on, the
REMOTE needs to be recharged.
The default setting time of REMOTE is 45 minutes. The REMOTE will shut off automatically after that time,
or you can manually turn off.
RECEIVER(S) CONTROL
Push and hold the power button on each RECEIVER until you can see the green light. Push again, and the
RECEIVER turns off. If the green light becomes red, the RECEIVER needs to be recharged.
INTENSITY
INTENSITY adjusting on the REMOTE is just below the LCD Screen figured as + and -. The more
you push + the HIGHER “UP” the Intensity level of the Channel shown in the LCD display goes.
- 4 - - 5 -
Intensity
Mode
Selection
Battery
Indicator
Channel
Selection
Intensity
Level