AWAY Drive Medical Design and Manufacturing 99 Seaview Boulevard, Port Washington, NY 11050 Contact Us: (877) 224-0946 Model # RTLAGF-900 REV2.4.9.
Contents 2 User manual English General Description 9 Contraindications 2 Intended Use 9 Warnings 3 Included in this Package 10 Precautions 4 Instructions for Use 12 Adverse Reactions 7 Application Duration 12 Troubleshooting 7 Electrode Placement 14 8 Tips for Skin Care Important Information Regarding Electromagnetic Compatibility (EMC) -1-
GENERAL DESCRIPTION The drive Wireless TENS/EMS System is a battery operated wireless pulse generator that sends electrical impulses from a REMOTE(A) control to RECEIVER(B) (round) with ELECTRODE(S), that are placed on the body to stimulate the nerves causing pain. When this happens, the nerves feel gentle electrical sensations instead of the pain. The Wireless REMOTE controls the ON/OFF of the system, the INTENSITY and the MODE functions of the RECEIVER(S).
INSTRUCTIONS FOR USE The REMOTE control has an LCD display, Intensity Up(+) and Down(–) and C button for choosing which RECEIVER you plan to adjust. Channel 1 controls RECEIVER 1, while Channel 2 controls RECEIVER 2. The M button is to control the MODE functions of the 2 RECEIVERS. Battery Indicator Mode Selection REMOTE CONTROL The slide SWITCH(1) on the bottom of the REMOTE is to turn the unit “ON” and “OFF”. Its LCD display lights up when the REMOTE is “ON”.
Channel The more you push - the LOWER “DOWN” the Intensity level of the Channel shown in the LCD display goes. Mode CHANNEL and RECEIVER CONTROLS Channel There are 2 RECEIVERS labeled 1 and 2. *RECEIVER 1 is Channel 1 and RECEIVER 2 is Channel 2. Both Channels/Receivers are controlled by the REMOTE. To use Channel 1 push the ‘C’ button on the REMOTE until you see 1 under the ‘C’ in the LCD display. Then set the MODE, by pushing ‘M’ on the REMOTE to see 1, 2, 3, 4 in the LCD display.
feel free to experiment. - The user should position the electrodes on the buttons of the RECEIVER(S) before placement. Both of the smaller electrodes need to be used at the same time in order for the unit to work. Do NOT peel the paper covering at the middle of large back electrode. Keep the clear electrode covering close by for protecting electrode sticky surface after removal. TIPS FOR SKIN CARE To avoid skin irritation, especially if you have sensitive skin, follow these suggestions: 1.
6. Do not apply stimulation over open wounds or rashes, or over swollen, red, infected, or inflamed areas or skin eruptions (e.g., phlebitis, thrombophlebitis, varicose veins). 7. Do not apply stimulation over, or in proximity to, cancerous lesions. 8. Do not apply stimulation in the presence of electronic monitoring equipment (e.g., cardiac monitors, ECG alarms), which may not operate properly when the electrical stimulation device is in use. 9.
14. Use caution if stimulation is applied over the menstruating or pregnant uterus. 15. Use caution if stimulation is applied over areas of skin that lack normal sensation. The user manual should advise users of the following: - Keep this device out of the reach of children. - Use this device only with the leads, electrodes and accessories recommended by the manufacturer. 16.
IMPORTANT INFORMATION REGARDING ELECTROMAGNETIC COMPATIBILITY (EMC) Drive PainAway Model# RTLAGF-900 Tens Conforms to EMC Standards As the number of electronic devices such as computers and cellular mobile telephones increases, medical devices in use may be at risk to electromagnetic interference from other devices. Electromagnetic interference may result in faulty operation of the medical device and create a potentially unsafe situation. Medical devices should also not interfere with other devices.
