Technical data

PowerStroll Owner’s Handbook Page 6 of 8 Part Code: Z24000
• We also recommend that the batteries are
not charged for more than 24 hours.
Operating the PowerStroll
• Reversing. The PowerStroll comes with a lift-
up strap to allow the wheelchair to reverse.
Lift up the PowerStroll with the strap and
hook the second loop around the push
handle. Please note that failure to lift up the
PowerStroll when reversing may cause the
pack to flip over.
• Maximum Speed. Always set a maximum
speed which you are comfortable walking
with.
• Pushing the Wheelchair When Not In Use.
We recommend that the powerpack is
restrained with the lift-up strap when not in
use.
Handset Operation
SPEED
DIAL
TRIGGER
POWER
EYE
OUTER
KNOB
INNER
KNOB
IGNITION
• Ignition – Insert the key and turn clockwise to
switch the PowerStroll on. Turn the key
anticlockwise to switch the PowerStroll off.
The key can be removed when the unit is
switched off.
Please note there is a 2-second delay when
starting up the PowerStroll before the wheel
will move. Wait 2 seconds before sequeezing
the trigger.
• Trigger – Squeeze the trigger to propel the
PowerStroll. The more the trigger is
squeezed, the faster the PowerStroll will
travel. Release the trigger to stop the
PowerStroll.
• Speed Dial – Turn the dial clockwise to
increase the maximum speed of the
PowerStroll. Turn the dial anticlockwise to
reduce the PowerStroll’s maximum speed.
• Power Eye – This is lit green when the
PowerStroll is switched on.
• Outer Knob – This is used to secure the clip
holding the handset to the push handle
• Inner Knob – This is used to determine the
angle of the handset.
Specification
• Weight: 10.8kg (single wheel w/o battery)
11.8kg (dual wheel w/o battery)
9.2kg (battery pack)
• Max speed: 4mph / 6.4kph
• Max gradient: 8º
• Cruising range up to 10 miles (16km)
• Weight capacity:
21 stone (135kg) including wheelchair & user
• Motor: 24V 150W D.C.
• Battery: 2x 12V 12ah Sealed Lead Acid
• Charger: 2A 24V output