™ OWNER’S HANDBOOK
Contents 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Safety Procedures Introduction Safety Procedures Parts Description Installation Instructions Disassembly and Transportation Battery Charging and Care Operating the PowerStroll Troubleshooting Specification Warranty Compatibility with Drive Wheelchairs • The PowerStroll must not be used solely by the wheelchair user under any circumstances. • Ensure the PowerStroll is installed as far to the rear of the wheelchair as is comfortable for the attendant to do so.
Parts Description HAND SET LIFT UP STRAP 2. BATTERY PACK Bracket Installation Install both brackets on the bottom horizontal tubing of the wheelchair, using an Allen Key. POWER PACK Ensure that the screws are sufficiently tight and do not rotate on the tubing. Attach the two sections of Velcro together. Installation Instructions 3. Powerpack Installation Feed the telescopic bar through the front end of the powerpack. Loosen the tristar knob on the bar and adjust to the correct length. 1.
5. 4. Remove the powerpack by pulling the Velcro strap whilst pulling the powerpack from the rear of the brackets (see the photo below). Battery Pack Installation Place the battery pack in to the battery tray as shown in the photograph. Secure the battery pack using the two Velcro strips on the side of the plastic battery tray. 6. Place all items in the carry holdall supplied.
Suggestion 1. Do not disconnect the charger cord if charging is not completed. The battery life will be seriously shortened or decayed if the battery is repeatedly used without being fully charged. Therefore be sure to charge the battery fully every time. 2. Always complete the charging until the LED light turns green. NEVER stop charging before it is complete. 3. When fully charged, the battery charger will still trickle charge the battery to ensure optimum range. 4.
• We also recommend that the batteries are not charged for more than 24 hours. • Speed Dial – Turn the dial clockwise to increase the maximum speed of the PowerStroll. Turn the dial anticlockwise to reduce the PowerStroll’s maximum speed. Operating the PowerStroll • Reversing. The PowerStroll comes with a liftup strap to allow the wheelchair to reverse. Lift up the PowerStroll with the strap and hook the second loop around the push handle.
the warranty period, parts will be supplied free of charge. TroubleShooting Wheelchair does not move when trigger is pressed. Note: The guarantee is not transferable. Possible Solutions: • Check the PowerStroll is switched on. 4. • Check the battery is fully charged. • Check the connection between the battery and motor is correct. 5. • Check the wheelchair brakes are not applied. • Check the drive wheel is in contact with the ground. 6. Wheelchair is difficult to push manually.
Compatibility with Drive Wheelchairs Compatibility with Other Wheelchairs The PowerStrolls are compatible with following Drive wheelchairs: The PowerStroll is suitable for most folding wheelchairs: • Budget Steel Wheelchairs (product codes: CS1142SP and CS1142TS) Steel Chair Wheelchairs – self propel (product codes: SSP16, SSP18, SSP18E and SUSP18) • with a distance between tubing edges (W) of 14½ ” to 20” (37cm – 50cm).
