Technical data
PowerStroll S-Drive Owner’s Handbook Page 6 of 8 Part Code: Z24001
Operating the PowerStroll
• Lift Up Strap. The PowerStroll comes with a
lift up strap to allow the wheelchair to move
when the PowerStroll is not in use. Lift up the
unit with the red strap and hook the second
loop around the push handle.
• Maximum Speed. Always set a maximum
speed which you are comfortable walking
with.
• Pushing the Wheelchair When Not In Use.
We recommend that the powerpack is
restrained with the lift-up strap when not in
use.
Handset Operation
TRIGGER
POWER
GAUGE
ON / OFF
BUTTON
FORWARD
BUTTON
REVERSE
BUTTON
REVERSE
BUTTON
• On / Off – Press the On/Off button to switch
the PowerStroll on and off.
Please note there is a momentary delay when
starting up the PowerStroll before the wheel
will move. Wait 2 seconds before sequeezing
the trigger.
• Trigger – Squeeze the trigger to propel the
PowerStroll. The more the trigger is
squeezed, the faster the PowerStroll will
travel. Release the trigger to stop the
PowerStroll. The direction of travel is
determined by the Forward and Reverse
buttons.
• Speed Dial – Turn the dial clockwise to
increase the maximum speed of the
PowerStroll. Turn the dial anticlockwise to
reduce the PowerStroll’s maximum speed.
• Battery Gauge – The battery gauge will show
how much power is remaining. The more of
the gauge is lit, the more power is left in the
batteries. The gauge also perform a sequence
of flashes if it has detected a problem with
the PowerStroll.
The problem may be listed below:
• 1 Flash – Flat battery.
Recharge battery.
• 7 Flashes – Trigger.
Release the trigger
and restart the PowerStroll.
If you experience any other flash sequences
restart the scooter. If the error persists
contact your Drive Medical Dealer.
• Forward Button. Press this button to allow
the PowerStroll to travel forwards. The LED
next to the button will light if forward motion
is selected.
• Reverse Button. Press this button to allow
the PowerStroll to travel in reverse. The LED
next to the button will light if reverse is
selected.
Specification
• Weight: 19.2kg (total)
10.2kg (without battery)
9kg (battery pack only)
• Max speed: 4mph / 6.4kph
• Max gradient: 8º
• Cruising range up to 10 miles (16km)
• Weight capacity:
21 stone (135kg) including wheelchair & user
• Motor: 24V 150W D.C.
• Battery: 2x 12V 12ah Sealed Lead Acid
• Charger: 2A 24V output
• Controller: PG Drives S-Drive 45A








