Owner’s Handbook
Contents 1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. Safety Procedures Introduction Safety Procedures Parts Description Installation Instructions Disassembly and Transportation Battery Charging and Care Operating the PowerStroll Troubleshooting Specification Warranty Compatibility with Drive Wheelchairs • The PowerStroll must not be used solely by the wheelchair user under any circumstances. • Ensure the PowerStroll is installed as far to the rear of the wheelchair as is comfortable for the attendant to do so.
Parts Description Handle Set Lift Up Strap Battery 2. Bracket Installation Install both brackets on the bottom horizontal tubing of the wheelchair, using an Allen Key. Power Pack Ensure that the screws are sufficiently tight and do not rotate on the tubing. Attach the two sections of Velcro together. Installation Instructions 3. 1. Handset Installation Loosen both screws on the plastic brackets. Attach the brackets around the push handle tubing, and reattach screws to secure.
5. 4. Remove the powerpack by pulling the Velcro strap whilst pulling the powerpack from the rear of the brackets (see the photo below). Battery Pack Installation Place the battery pack in to the battery tray as shown in the photograph. Slide the battery pack forwards until it locks in position. 6. Place all items in the carry holdall supplied. Notes: • The battery supplied with the PowerStroll is classified as safe for air travel by compliance with IATA special provision A67.
Suggestion 1. Do not disconnect the charger cord if charging is not completed. The battery life will be seriously shortened or decayed if the battery is repeatedly used without being fully charged. Therefore be sure to charge the battery fully every time. 2. Always complete the charging until the LED light turns green. NEVER stop charging before it is complete. 3. When fully charged, the battery charger will still trickle charge the battery to ensure optimum range. 4.
Operating the PowerStroll • Lift Up Strap. The PowerStroll comes with a lift up strap to allow the wheelchair to move when the PowerStroll is not in use. Lift up the unit with the red strap and hook the second loop around the push handle. • Maximum Speed. Always set a maximum speed which you are comfortable walking with. • Speed Dial – Turn the dial clockwise to increase the maximum speed of the PowerStroll. Turn the dial anticlockwise to reduce the PowerStroll’s maximum speed.
the warranty period, parts will be supplied free of charge. TroubleShooting Wheelchair does not move when trigger is pressed. Note: The guarantee is not transferable. Possible Solutions: • Check the PowerStroll is switched on. • Check the battery is fully charged. • Check the connection between the battery and motor is correct. • Check the wheelchair brakes are not applied. • Check the drive wheel is in contact with the ground. 4. 5. 6. Wheelchair is difficult to push manually.
Compatibility with Drive Wheelchairs Compatibility with Other Wheelchairs The PowerStrolls are compatible with following Drive wheelchairs: The PowerStroll is suitable for most folding wheelchairs: • Drive Wheelchairs (product codes: SSP118FA-SF, K318ADDA) Budget Steel Wheelchairs (product codes: CS1142SP and CS1142TS) • with a distance between tubing edges (W) of 14½5” to 22” (37cm – 55cm).
