® Covers: LAWC003 - Lightweight PowerSTROLL single wheel LAWC010 - Lightweight PowerSTROLL dual wheel Wheelchair not included Lightweight PowerSTROLL Owner’s Handbook
Contents 1. Safety Procedures Introduction The PowerStroll must not be used solely by the wheelchair user under any circumstances. 2. Safety Procedures 3. Parts Description Ensure the PowerStroll is installed as far to the rear of the wheelchair as is comfortable for the attendant to do so. 4. Installation Instructions 5. Disassembly and Transportation Operate the PowerStroll at a speed that is both comfortable for the operator and wheelchair user. 6. Battery Charging and Care 7.
Parts Description 2. Installation Instructions Bracket Installation Install both brackets on the bottom horizontal tubing of the wheelchair, using an Allen Key (as shown in the photo above) Ensure that the screws are sufficiently tight and do not rotate on the tubing. Ensure that the hole on each bracket is horizontal and level with each other. 1. Handset Installation Loosen both knobs on the handset. Squeeze the crocodile clip on the handset and apply to the push handle as shown.
5. Final Connection Connect the cable from the powerpack in to the underneath of the handset (as shown previously). Place the top loop of the lift-up strap around the opposite push handle to the handset. Disassembly and Transportation 1. 2. 3. 4. 5. Switch the PowerStroll off at the ignition. Disconnect / unclip the powerpack connector from underneath the handset. Remove the lift-up strap from the push handle.
7. The orange LED will turn green when charging is complete. 8. Turn off the charger, disconnect the power cord and the round plug from the battery pack. 9. Suggestion 1. Do not disconnect the charger cord if charging is not completed. Battery longevity will be seriously reduced if the battery is repeatedly used without being fully charged. Therefore be sure to charge the battery fully every time. 2. Always complete the charging until the LED light turns green.
Charging the Batteries Using the charger supplied, the charging duration is about 8 hours. However, to ensure optimum performance we recommend a 12-hour charge. We also recommend that the batteries are not charged for more than 24 hours. Reversing (Single Wheel). The PowerStroll comes with a lift-up strap to allow the wheelchair to reverse. Lift up the PowerStroll with the strap and hook the second loop around the push handle.
Steel Chair Wheelchairs – self propel (product codes: SSP16, SSP18, SSP18E and SUSP18) Specification Weight: 7.5kg (without battery) Steel Chair Wheelchairs – transit (product codes: STS16, STS18, STS18E and SUTS18) 6.
6. Manufacturer Details 7. Drive Medical Ltd, Ainley’s Industrial Estate, Elland, GB HX5 9JP. Warranty 8. To improve the safety and lifespan of your PowerStroll, it is recommended that you have it serviced on a regular basis. Recommended Service Schedules for PowerStrolls are available to service agents. There is a comprehensive twelve-month warranty from the date on which your new PowerStroll is delivered. The warranty covers the PowerStroll for replacement parts during this period.
