Owner's Manual

1-2cm

''(0.4-0. 8)

1413

DIA

ULSE

SET

min

START

TOP

Unit Operation

Unit Operation Unit Operation

Unit Operation

System Settings

With power off, press "SET" button to activate System Settings. The Memory Group icon

ﬂashes.

1. Select Memory Group

While in the System Setting mode, you may accumulate test results into 2 different

groups. This allows multiple users to save individual test results (up to 60 memories per

group.) Press “ M ” button to choose a group setting. Test results will automatically store

in each selected group.

2. Time/ Date Setting

Press “SET” button again to set the Time/Date mode. Set the month ﬁrst by adjusting the

“ M ” button. Press “SET “ button again to conﬁrm current month. Continue setting the

day, hour and minute in the same way. Every time the “ SET “ button is pressed, it will

lock in your selection and continue in succession (month, day, hour, minute.)

Applying the Arm Cuff

1. Firmly insert air plug into opening located on left side of monitor unit.

2. With sticky nylon section facing outward, insert end of cuff underneath metal ring of cuff.

3. Fasten cuff about 1-2cm (0.4-0.8") above the elbow joint. For best results apply cuff to

bare arm and keep level with heart while testing.

Note: Do not insert air plug into opening located on right side of monitor unit.

This opening is designed for an optional power supply only.

Testing

1. Power On

Press and hold “ START/STOP ” button until a beep sounds. The LCD screen will appear

for one second as unit performs a quick diagnosis. A long tone indicates device is ready

for testing.

Note: Unit will not function if residual air from previous testing is present in cuff.

The LCD will ﬂash "

" until pressure is stabilized.

3. Saved Settings

While in any setting mode, press “ START/STOP “ button to turn the unit off.

All information will be saved.

Note: If unit is left on and not in use for 3 minutes, it will automatically save all

information and shut off.

1 2