Product Manual

14 15
Chapter 16 : APPLICATION OF RE-USABLE SELF
ADHESIVE ELECTRODES
Application
1. Clean and dry the skin at the prescribed area thoroughly with soap and water
prior to application of electrodes.
2. Insert the lead wire into the pin connector n the pre-wired electrodes.
3. Remove the electrodes from the protective liner and apply the electrodes firmly
to the treatment site.
Removal
1. Lift at the edge of electrodes and peel; do not pull on the lead wires because it
may damage the electrodes.
2. Place the electrodes on the liner and remove the lead wire by twisting and pull
ing at the same time.
Care and Storage
1. Between uses, store the electrodes in the resealed bag in a cool dry place.
2. It may be helpful to improve repeated application by spreading a few drops of
cold water over the adhesive and turn the surface up to air dry. Over Saturation
with water will reduce the adhesive properties.
Important
1. Do not apply to broken skin.
2. The electrodes should be discarded when they are no longer adhering.
3. The electrodes are intended for single patient use only.
4. If irritation occurs, discontinue use and consult your clinician.
5. Read the instruction for use of self-adhesive electrodes before application.
Chapter 17 : ADJUSTING THE CONTROLS
1.Slide Cover:
A slide-on panel covers the controls for Contraction Time,
Relaxation Time, Ramp Time, Pulse Width, and Pulse Rate.
Your medical professional may wish to set these controls
for you and request that you leave the cover in place.
2.Power On/Off Switch and Intensity Controls:
If both controls are in the off-position, the device is switched
off.
By turning the controls clockwise, the appropriate channel
is switched on and the indicator of power (a dot) will reveal
on the LCD.
The current strength of the impulses transmitted to the electrodes increases
further when the control is turned clockwise.
To reduce the current strength or switch the device off, turn the control counter
clockwise to the required setting or off-position, respectively.
PDF created with FinePrint pdfFactory trial version http://www.pdffactory.com