CHAD 50 PSI COMPRESSOR PATIENT INSTRUCTIONS MODEL # 18450
CONTENTS Page No. GENERAL INFORMATION………….…………………………….………1 -Safety Precautions……………………………………………………….2 -Basic Operating Parts……………………………………….……………3 OPERATING INSTRUCTIONS……………….……………….………….4 -Initial Positioning and Installation….……………………….……….……4 -Operation……………………………..…………………………………4 ROUTINE MAINTENANCE………………….…………….………….…..5 -Removing and Cleaning the Air Intake Filter..……………………….……5 SPECIFICATIONS………………………………………….…..….………6 TROUBLE SHOOTING…………………………………….….….……….7 -Trouble Shooting Chart……………………………………….
GENERAL INFORMATION This manual provides information necessary to operate the 50 PSI Compressor. This unit is designed for the most efficient, continuous high pressure performance. The compressor provides the high pressure which clinical studies have indicated are required for optimal particle size (2 microns or less) . It operates quietly and effectively due to the unique design of the WOB-L piston. Easy to clean, very low maintenance, compact, light-weight, and portable.
SAFETY PRECAUTIONS When using electrical products, especially when children are present, basic safety precautions should always be followed. Read all instructions before using. Important information is highlighted by these terms: DANGER Urgent safety information for hazards that will cause serious injury or death. WARNING Important safety information for hazards that might cause serious injury. CAUTION Information for preventing damage to the product.
BASIC OPERATION PARTS PRESSURE GAUGE Indicates pressure output REGULATOR determines Pressure output HANDLE INTAKE FILTER OUTLET POWER RESET restarts unit after overload POWER CORD ON/OFF SWITCH starts and stops unit "On" position FIGURE 1 "Off" position 3
OPERATING INSTRUCTIONS INITIAL POSITIONING AND INSTALLATION 1. Select a suitable location for the unit near a 120 VAC / 230VAC, grounded power Outlet. 2. Grasp handle on top of cabinet and position the unit so that operating controls are Accessible to the user and back of unit is away from wall. 3. Make certain that the power switch located in the center of the control panel is in the OFF position and plug power cord into grounded power outlet or grounded adapter. 4.
ROUTINE MAINTENANCE REMOVING AND CLEANING THE FILTER Pull air intake filter out from front of unit and replace with a new one when dirty. Do not wash it. Caution Do not submerge in water as this will result in damage to the vacuum pump.
SPECIFICATIONS / CLASSIFICATIONS / Symbols Size (L) x (W) x (H) : 15” x 10-5/8” x 18.1” Weight: 17.
TROUBLE SHOOTING If the compressor malfunctions, refer to the trouble shooting chart below for probable cause and remedy . If you can not get the machine to operate, call your home care provider . TROUBLE SHOOTING CHART PROBABLE CAUSE TROUBLE REMEDY A. Unit not operating 1. Plug not firmly in wall. 2. No power at wall outlet 1. Check plug at outlet . 2. Check power source, fuse in house B. Limited air flow 1. Faulty Delivery Tubing. 1. Disconnect delivery tubing at outlet . If proper flow is 2.
1 YEAR LIMITED WARRANTY Your Drive brand product is warranted to be free of defects in materials and workmanship for one (1) year of the original consumer purchaser. This device was built to exacting standards and carefully inspected prior to shipment. This 1 Year Limited Warranty is an expression of our confidence in the materials and workmanship of our products and our assurance to the consumer of years of dependable service.
