Product Manual

Owner's((Manual(|(REV(001( (
(
(
30(
Replacing Actuators
• Unplug power supply cord from the wall outlet
• Identify the actuator to replace
• Tip bed on its side to remove the Hi/Lo actuators
• Unplug actuator cord from control box
• Actuator is held in place by (2) clevis pins
• Remove bowtie clips from clevis pins
• Slide the clevis pins out of the holes
• You can now replace the actuator
• To reassemble bed, reverse previous steps, and make sure to:
- Assemble clevis pins as originally installed with bowtie clips
- Zip ties should be replaced, with cords to their original position and routing
direction to the control box
Replacing the AC Power Cord
• Unplug power cord from wall outlet
• Unplug the power cord from the control box
• Remove tie-wraps holding power cord in place on frame
• Plug the new power cord into the control box
• Route the new power cord in the same manner as the original cord ensuring use of strain
relief device
• Replace tie-wraps to hold power cord to frame
• Plug power cord back into wall outlet
END OF LIFE DISPOSAL
• Many components of this product may be recycled.
• Please dispose of non-recyclable items properly.