Product Manual

Owner's((Manual(|(REV(001( (
(
(
27(
CARE AND MAINTENANCE
CAUTION
If improperly performed, equipment or property DAMAGE or resident INJURY is possible during
maintenance.
Cleaning Instructions
• If possible, remove resident before cleaning bed.
• Unplug power supply cords prior to cleaning.
• Ensure all electrical parts (motors, control boxes, pendant and cables) are not broken
and all housing components are unplugged. Ensure that NO liquids enter electrical
components.
• Remove all gross/solid contaminants, then wash and sanitize all components. DO NOT
submerge the bed frame or electrical components.
• Use standard water pressure. DO NOT power wash or steam clean any parts.
• Do NOT use Solvents, alcohol, bleach, caustic agents, high acid or alkaline solutions or
petroleum based products to clean the bed surface.
• Rinse completely with water (Maximum temperature 110°F or 43°C).
• Ensure all components are dry before using or storing.
Note: This bed is NOT compatible with wash down tunnels.
WARNING
Failure to properly maintain your bed may decrease the life expectancy of your product and
increase product maintenance requirements and costs. Always service the bed at the required
intervals.
MAINTENANCE
Inspection of All Components – Receipt of assembled bed
• Check bed components for obvious damage.
• Inspect power supply cords for cuts and/or damage.
• Check that actuator cords are connected properly to the controller.
• Verify proper functionality of all features.
QUARTERLY MAINTENANCE CHECK
• If the bed has a battery, unplug from the wall outlet and validate function. The battery
may be built-in or portable.
• Inspect bed and Assist Bars/Rails bolts, if loose tighten and if missing replace.
• Lubricate clevis pins at hinge points.
• Lubricate tracks of bed for smooth travel.