Product Manual

Owner's((Manual(|(REV(001( (
(
(
22(
BATTERY BACK-UP *(Option for #15902C only)
Tool List: Phillips Screw Driver and 9mm wrench and socket/driver
• Mount the plastic battery mounting bracket to the steel battery plate using the 6 #8
screws and nuts included.
• Install the battery mounting plate to either side of the center of the bed frame using the 4
3/8" bolts and washers included.
• Slide the battery into place; make sure it is secure into the mounting bracket.
• Attach the cord from the battery into the control box (black color).
• The battery back-up will now work if the bed becomes unplugged from the wall outlet or
there is a power failure.
CRUSH HAZARD
Installation of the battery backup creates a possible foot crush hazard. Drive Medical
recommends that the battery backup is installed on the side of the bed that is against
the wall to minimize this crush hazard.
IMPORTANT INFORMATION ABOUT YOUR BATTERY BACKUP!
" The battery backup should be used for EMERGENCY PURPOSES ONLY
" DO NOT use the battery backup to demo or display a bed
" If the battery backup is used, it MUST be recharged before becoming drained
and dormant. If the battery is run dead and left for any extended portion of time,
the battery can go into HIBERNATION and cannot recover or be recharged.
" Drive Medical cannot be held responsible for improper backup use.