Product Manual

Owner's((Manual(|(REV(001( (
(
(
14(
UNPACKING AND ASSEMBLY
UNPACKING INSTRUCTIONS
Tools needed: wire cutters or pliers
CAUTION
DAMAGE to the equipment may occur if the incorrect zip ties are removed.
• If the carton is in an upright position, slowly lower to the floor and position with casters
down.
• It may be necessary for two or more people to help in lowering the bed.
• Cut black strapping around box; remove box ends and plastic surrounding bed frame.
• Cut zip ties to remove wall guard at the head of the bed.
• Cut the zip ties to remove mattress retainers on each side of the bed.
• Remove ties from pendant.
• Remove any remaining zip ties or foam left on bed frame.
• Locate power cord and plug into grounded 110-240 VAC outlet.
• Raise the bed frame and check to make sure everything is plugged into the control box
and no wires are loose. If wires are not in control box, match up by the color coded
system. (See instructions below)
NOTE: DO NOT remove zip ties that are holding cords underneath bed frame.
INITIAL INSPECTION
Inspection of All Components – Receipt of assembled bed
• Check bed components for obvious damage.
• Inspect power supply cords for cuts and/or damage.
• Check that actuator cords are connected properly to the controller.
• Verify proper functionality of all features ONCE ASSEMBLED.