Product Manual

To stop Rollator apply weight downward on handlebars.
This will engage tips and bring the Rollator to a stop.
assembly instructions
Do not aempt to adjust or operate Rollator without
carefully reading all instructions in this manual.
1. First remove all contents from carton: backrest,
handle with tube, Rollator frame and Basket.
2. Open frame and slide padded backrest into frame
brackets making sure snap booms protrude
through holes.
3. Loosen tightening knob on handle receptacle and
insert handle tube into frame. The brake cable should
be positioned on outside of frame. Set handle to
desired height. Tighten knob by turning clockwise
until handle is securely in place. Make sure both
handles are set to the same height before use.
1. Please make sure the Rollator is fully opened, seat
is down and the folding bar under seat is locked in the
down position.
2. Be sure that both knobs are fully tightened and are at
equal heights. Test Rollator for stability before
applying full weight to hand grips.
3. Test the loop locks before operating the Rollator.
When wheels are locked (see illustrations for locking
and releasing locks below), lock bar on rear wheels
should prevent wheels from turning. If the wheels
turn while brakes are locked, please take unit back
to dealer for adjustment. When locks are released,
the wheels should turn freely.
4. Always lock loop locks before siing and do not use
seat when unit is on an incline or uneven ground.
5. Replace tires when significantly worn or damaged.
safety precautions
to stop rollator
Orthodic
Hand Grips
Height
Adjustable
Wide
Comfortable
Seat
Folding
Hinge for
Portability
Backrest
Important Safety Notice
Do not have anyone push you while you are seated on
the Rollator. This is a walking aid only and is not to be
used as a transportation device.