Data Sheet

© Copyright by Drive-System Europe Ltd. Stand: 15.11.2018
Additional technical data
•
push/pull force up to 1000N
• Static load up to 4.000N (by spindle type A6)
• Noise Level ≦ 65dB
•
Aluminium outer tube and stroke rod
• Voltage 12V or 24V
• Operating temperature -26C°-65C°
• Protection type IP54
•
Duty cycle 10% or
2min continuous operation in 18min
• CE
• EMC Directive 2014/30/EU and
2004/108/EC
Dimension
Linear-actuator
DSZY30 -
Length
Mass
in mm
Stroke (S) 50 100 150 200 250 300
Piston rod – No.: 3
A
retracted length
306 356 406 456 506 556
B
extended length
356 456 556 656 756 856
Piston rod – No.: 9
A
retracted length
332 382 432 482 532 582
B
extended length
382 482 582 682 782 882
Piston rod – No.: 1 o. A
A
retracted length
315 365 415 465 515 565
B
extended length
365 465 565 665 765 865
Mounting instruction
Please make sure, that load is not bigger than shown in the table „Speed – current“. To protect the actuator against overloading, it must be
turned off, when maximum current is reached. This can be read from the table depending on the particular type of spindle. Please use the right
voltage supply as it is shown on the actuator.
For extending the piston rod connect the red cable with plus and the black cable with minus. Movement is stopped automatically, when the limit
switches are reached. For moving back, reverse the polarity (change plus and minus). Limit switches are not adjustable by the customer.
Load should always be centered in moving direction. Transverse forces should be avoided, because of shortening the lifetime.
Big transverse forces can destroy the actuator.
Drive-System Europe Ltd.
www.drive-system.com
[e-mail]