Datasheet

© Copyright by Drive-System Europe Ltd. Stand: 02.05.2016
Dimension
Linear actuator
Length
Ma
ss
in mm
Stroke ± 2mm 100 150 200 250 300
DSZY4 - type standard
A
205 255 305 355 405
B
305 405 505 605 705
x1: Standard = 10mm
Optional = 8mm
Accessories
Front-Connector
C1x - is standard
Attention: by C3x heightens itself the
dimension A or B about 41mm
Mounting instruction
Please make sure, that load is not bigger than shown in the diagram speed/load. If overload is possible in the application,
please use a separate current control to switch off at too high current ( = too high load ). Nominal current, depending on
ratio, is shown in the diagram current / load.
Please use the right voltage supply as it is shown on the actuator. For extending the piston rod connect the red cable with
plus and the black cable with minus. Movement is stopped automatically at the end of the stroke. For moving back,
reverse the polarity (change plus and minus). Endswitches are not adjustable by themselves.
Load should be centered in moving direction, shear forces should be avoid because of shortening the lifetime. Big shear
forces can destroy the actuator! Be carefull.
Drive-System Europe Ltd.
www.drive-system.com
[e-mail]