Datasheet

Dimension

Linear actuator

Length

Mass in mm

Stroke 25 50 100 150 200 250 300

DSZY1 - type potentiometer

A 165 195 246 297 348 399 450

B 190 245 346 447 548 649 750

Poti-resistance KOhm 0,3-9,3 0,3-9,7 0,3-8,6 0,3-9,6 0,3-9,3 0,3-9,3

Gea

C1x – is standard

Options: C2x or C3x

Attention:

By C3x - the dimension A and B lengthens itself

about +41mm

Mounting für actuator

Clamp: DSZY1-H01

Mounting Bracket: DSZY1-H02

Please additionally order

Mounting instruction

Please make sure, that load is not bigger than shown in the diagram speed/load. If overload is possible in the application, please

use a separate current control to switch off at too high current ( = too high load ). Nominal current, depending on ratio, is shown

in the diagram current / load.

Please use the right voltage supply as it is shown on the actuator. For extending the piston rod connect the red cable with plus

and the black cable with minus. Movement is stopped automatically at the end of the stroke. For moving back, reverse the

polarity (change plus and minus). Endswitches are not adjustable by themselves.

Load should be centered in moving direction, shear forces should be avoid because of shortening the lifetime. Big shear forces

can destroy the actuator! Be carefull.

Drive-System Europe Ltd.

www.drive-system.com

engineering@drive-system.com