Datasheet

ManualsBrandsDrive System Europe by MSW ManualsAutomationLinear actuator DSZY5-230-40-610-LT-IP65 Stroke length 610 mm Thrust 3500 N 230 V AC 1

Linear actuator DSZY5-LT

(limit switch)

The electric linear actuators DSZY5 are operated with alternating current.

The DSZY5 linear actuator is available in four different models:

• DSZY5-STD (Standard)

(standard for all applications without position feedback)

• DSZY5-POT

(with potentiometer for absolute position feedback)

• DSZY5-LT

(with integrated, adjustable limit switches)

• DSZY5-LT-POT

(with potentiometer and integrated, adjustable limit switch)

Equipped with a trapezoidal screw spindle (ACME screw), it is a

durable and robust AC linear drive. Thanks to the trapezoidal

threaded spindle, it achieves high self-locking.

In addition, mechanical overload protection has been integrated.

The motor is also protected by a temperature overload protection.

Type code (all options can be combined)

DSZY5 -

230 -

10 - 203 -

IP65

Type Input

voltage

230 Vac

Gear

reduction i

Stroke

102 mm

153 mm

203 mm

254 mm

305 mm

457 mm

610

Model

LT (with integrated,

adjustable limit switches)

IP Code

Performance data: Load – Speed – Current

Gear

reduction i

Dynamic

load

(N)

Static

load

(N)

Typical speed *

(mm/s)

Typical current *

(A)

minimum

laod

maximum

load

minimum

laod

maximum

load

10 1,500 ca. 2,500 26.5 22.9 2.8 3.1

20 2,500 ca. 3,500 13.1 11.8 2.7 2.7

40 3,500 4,500 6.6 6.0 2.7 2.7

Load – Speed – Diagram * Load – Current – Diagram *

(*) Average values

Summary of content (4 pages)

PAGE 1
Linear actuator DSZY5-LT (limit switch) The electric linear actuators DSZY5 are operated with alternating current.
PAGE 2
Additional technical specifications • Thrust and tensile force up to 3,500 N • Static load: 4,500 N (by i=40) • Duty cycle 25 % (e.g.
PAGE 3
Front and rear connector Rear connector all Types Font connector (piston rod) LT, POT, LT-POT Fastening to the gearbox cover Note: As an example in 0° orientation By default, the bore hole of the gear cover has an angle of 90°. Optionally, another angle (see picture) can be selected. The angle between the selectable steps is 30°. Options C1 to C5 must be attached to the type code: DSZY5…..
PAGE 4
Installation instructions It must be ensured that the load is not greater than shown in the diagram. To protect against overload, the voltage must be switched off when the maximum rated current is reached. This can be read in the load-current diagram depending on the selected reduction ratio. Please note the correct supply voltage, which is indicated on the electric linear actuator. The piston rod is secured against twisting. The load must always be centered in the direction of movement.