User Manual

9
Assembly Instructions Cont.
A6. After the motor is installed, slide locking covers back on motor.
A8. Attach the foot board and head board
as shown.
a. NOTE: The head section is higher than
the foot section. However, they are
interchangeable with each other, with all
other Drive and other manufacturers
head and foot boards.
A7. Install the casters by inserting the
stem of the caster into the leg
receptacle. It is recommended to
install 1 locking caster and 1 non-
locking caster on each bed end.
The locking casters should be
installed diagonally from each other.
Stem
Leg Receptacle
End Method A
Go To Page 12, Step 8
Method A (Continued)
A5. With the palm of your hand, snap the motor
ush to the actuator bar.